The automatic concrete block making machine is a non-burn block making machine to make bricks through hydraulic pressing. It is also very ECO-friendly because its raw materials are fly ash, river sand, sea sand, mountain sand, mineral powder, slag, stone powder, coal slag, coal gangue, tailings slag, chemical slag, etc.
The auto brick making machine consists of batching machine, mixer, conveyor belt, hydraulic brick machine, palletizer,etc. The conveyor belt is one of the commonly used parts in the concrete block plant.
It connects the various parts and ensures the coordinated operation of the brick machine. If it is improperly installed during use, it may cause damage to the belt and affect the service life of the conveyor belt. The correct inspection and correction methods are particularly important.
Firstly, we need to check whether the two ends of the conveyor belt are aligned in the horizontal direction, and check the alignment of the horizontal centerline of the idler and the longitudinal centerline of the belt conveyor. If the deviation exceeds 3mm, both ends need to be adjusted.
Then check whether there is deviation in the vertical direction and of the two planes of the head and tail frame. If the deviation of the plane exceeds 1mm, you need to readjust it to the same plane.
And you also need to observe if the material is located in the middle of the conveyor belt. If the material is on the left or right, it will affect the transmission efficiency of the material and can be improved by adding baffles.
The unstable operation of the conveyor belt of the hydraulic concrete block making machine is mainly due to the misalignment of the installation. It it must be aligned to keep the error within the allowable range.
If you buy the concrete brick making machine from Haomei Machinery, we can provide installation guide or service. Welcome to inquire from us if you need it.